• CN3791 6V MPPT Solar Charger Module NEW
  • CN3791 6V MPPT Solar Charger Module NEW

CN3791 6V MPPT Solar Charger Module

Arduino components
Availablity In stock
10 JOD
7 JOD
CN3791 6V MPPT Solar Charger Module
This is a maximum power point tracking (MPPT) solar charger for single-cell LiPo batteries. This MPPT solar charger provide you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargeable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the solar charger and your battery into the other and you are good to start charging! Solar maximum power point tracking (MPPT) is to ensure that the light intensity change, photovoltaic cells output maximum power, to make full use of solar energy. In general, need to use a switch mode DC – DC converter to realize MPPT function, keep the output voltage and charging current product maximize (output). The output of the Solar Charger is intended to charge a single polymer lithium ion cell. The load should be connected in parallel with the battery. Each Solar Charger comes equipped with a CN3791 power tracking battery charging circuit and pre-installed four 2-pin JST/PH2.0 connectors. Specifications: Input voltage: select the corresponding module according to the nominal voltage of the solar panel (6V/9V/12V) Output voltage: nominal 3.7V full charge voltage 4.2V lithium battery Interface: 2-pin JST connectors (or PH2.0) Max Charging current: 2A PWM switching frequency: 300KHz Charging voltage: 4.2V ± 1% Working environment temperature: -40 ° C to +85 ° C PCB Size:45X20X9.5mm Package Included: 1 x CN3791 6V MPPT Solar Charger Module 1 x Pair of wires with 2-pin JST connector on both sides;

Recent Products